You are logging into the RoguFab.com Forum (message board/discussion). To log into your RogeFab.com shop account, click here
Notifications
Clear all
Topic starter
18/01/2021 6:10 pm
I was having a hard time getting the auto cut feature to work correctly. The pick points mated to a flat plane would show the tubes cut on one half, not the other.
I called bend tech and they sent me a new newly released patch.
Now the tube will extend out past the pick points, allowing the real, complete cut profile to be determined.
So if this is happening to you, just call and get the patch emailed. You'll need the serial number.
31/01/2021 10:08 am
Appreciate the information. I use Bend Tech for all my bending that way I have a backup if I need to make it again for someone else.